项次 No | 项目 Item | 内容 Content | 时机 Period | 备注 Remark |
01 | 送风马达转向 Rotating direction | 转向须与箭头指示相同 The direction must be the same with the arrow | 机台安装后 After installation | |
02 | 机台箱内 Interior space | 保持箱内清洁 Keep cleaning | 随机 Random | |
03 | 机台顶盖通风孔 The vent on the top of oven | 保持通风孔通畅 Keep fluent | 每月 Each month | |
04 | 电气配电盘 Control cabinet | 保持配电盘清洁及固定螺丝牢固 Keep clean and all screws are fixed | 每月 Each month | |
05 | 接地线 Grounding cable | 保持接地状态 Keep with ground | 随机 Random | |
06 | 超温防止器 Over Temp. protector | 确定温度设定正确 Make sure the setting Temp. is correct. | 随机 Random | |
07 | 温度感应线 Thermo couple | 确定感应线未脱落 Make sure the couple is fixed | 随机 Random | |
08 | 进排风管 Exhausting pipe | 保持风管通畅 Keep fluent. | 一或三个月 1 or 3 months | 视客户环境而定 Depends on the environment |
09 | 送风风轮 The fan | 保持风轮清洁 Keep cleaning | 半年或一年 Half or one year |
视客户环境而定 Depends on the environment |
10 | 机台各部螺丝 The screws in whole oven | 保持螺丝牢固 Keep them is locked
| 随机 Random | |
11 | 电磁接触器 Electronic contactor | 更换 Replace it | 每年 Each year |
＊ 若温控器为RELAY控制时，请定期检查，以免因故障造成温控器功能失效。
＊ If the Temp. controller is controlled by RELAY. Please check it often to avoid Temp. controller malfunction.
